Causes and Solutions of Industrial Tablet Computer Failures

With the continuous progress of industrial display technology, the application of industrial tablet computer is more and more widely. It is very normal for industrial tablet computers to have some failures after they have been used for a long time, such as slow operation, frequent freezes or crashes. These aren’t big problems, and once we figure out what causes industrial tablets to malfunction, they’re easy to fix.

The industrial tablet computer runs slowly, jams and freezes, mainly caused by the following reasons, and I will introduce it to you.

First, the influencing factors of industrial tablet PC configuration. The speed of an industrial tablet has a lot to do with its configuration, and the higher the configuration, the faster it will run. If the PC is low spec, it can’t run fast enough, so when you use an industrial tablet, it can’t keep up and crash. To solve this problem, trade in a higher-spec industrial tablet or simply buy a higher-spec industrial tablet.

Second, the industrial tablet computer system disk capacity is insufficient. If the system disk capacity of an industrial tablet is insufficient, and then to run some software, the crash is inevitable. The system disk is the space carrier for the system and software programs of industrial tablet computers. When the space of the system disk is insufficient to run the programs, the crash will occur. Therefore, we need to clean up the system disk frequently, clean up the system garbage files and transfer some non-system files to other storage disks. When we usually install software programs do not install in the system disk, installed in other disks can save a lot of space for the system, to avoid the occurrence of system disk space shortage caused by the crash phenomenon.

Third, industrial tablet computers run too many programs caused by failure. When industrial tablets run too many programs, they take up a lot of memory. And when the memory is used for more than half of the time, there may be a crash. This is unavoidable and a common cause of crashes. In this case, try to minimize unnecessary running of programs or increase the memory capacity of the industrial tablet.

Finally, too many desktop files on industrial tablets lead to failures. When using an industrial tablet, many people like to put files on the desktop, which is convenient, but it’s limited to a small number of files. And when too many files even spread across the entire desktop, it will be dazzling to see, and it is very troublesome to find the files you need. Most importantly, desktop files take up system disk capacity, which is one of the causes of industrial tablets crashing. Therefore, desktop files on industrial tablets should often be classified and saved to other disks, so that it is easy to find the files you need, but also to alleviate the space problem of the system disk.

In addition to hardware configuration factors, many failures in the use of industrial tablets are caused by personal habits, which can be completely avoided, which requires us to have a good habit of using industrial tablets.